GE
Dishwasher Fault Codes - From the Late 1990's forward
|
| Display |
Condition
|
Remedy |
| PF |
Power
Failure |
Push
cancel to clear. If code persists check electrical connections
to dishwasher and electronic control |
| C1 |
Partially
restricted drain, pump-out not accomplished in the normal
time of less than 95 seconds |
Check
drain line, if clear, check for a restricted drain valve in
pump |
| C2 |
Drain
line totally blocked, pump-out not accomplished in the maximum
time of 405 seconds |
Check
drain valve for restriction in pump, check drain line. Note:
If a new garbage disposer was installed, remove knock out
plug for dishwasher drain |
| C3 |
Will
not go into drain |
Call
for service |
| C4 |
Water
over-fill fault |
Check
for high water pressure to unit, usually an indication of
a bad water inlet valve |
| C5 |
Low
water fill |
Check
for low water pressure to unit, usually an indication of
a bad waiter inlet valve |
| C6 |
Water
temperature too low after 20 minute extension |
Check
heating element and thermostat, both should have continuity |
| C7 |
Temperature
sensor bad |
Replace
sensor (located inside door, remove door panel to access)
|
| C8 |
Detergent
cup blocked |
Keep
objects clear of cup when loading |
